Description
The K-Tuned K20Z3 No-Cut Shifter is designed to be used in all EF, DA, EG, DC2 and EK chassis and of course, as the title states, it is installed with absolutely no cutting of the exhaust tunnel. On a manual chassis, use the OEM shifter linkage holes for the rear and simply drill 2 more holes up front and you're done. The aluminum mechanism for the shifter will then bolt in place up top and the arms will pass down through the factory shifter hole. The bottom section where the cables are connected is fully sealed and 100% leak-free unlike some other designs where water and exhaust gases can actually get inside the shifter and the cabin.
The shifter was designed to be used with 06-11 OEM Civic Si shifter cables. These cables will bolt-on like OEM and even the stock center console and cup holders can remain in place.
Features:
- Works with K20Z3 shift selector & cables
- Keep center console and cupholders in place
- Perfect for K20Z3 swaps
Related Products


K-Tuned
K-Tuned No-Cut K-Swap Shifter


K-Tuned
K Tuned Shifter Mounting Kit for K Swap

K-Tuned
K-Tuned Shifter Box Bushings

K-Tuned
K-Tuned Shifter Cable Grommet

K-Tuned
K-Tuned Shifter Cables and Brackets Kit for F / H Series Transmission (use with K-Tuned Shifter)
Customers Also Viewed


K-Tuned OEM Spec Shifter Cables with Billet Bushings 02-06 RSX

K-Tuned K20-Swap Silicone Radiator Hoses for use with RSX Radiator

K-Tuned OEM thermostat Housing Plug and Bracket


K-Tuned
K-Tuned No-Cut K-Swap Shifter

K Tuned Pre-Fit Heater Hoses for Honda K Series Engine Swap

K-Tuned Passenger Side Radiator Kit EG EK K-Swap

K-Tuned K Swap Fuel System (OEM) 6AN Lines Rail FPR Gauge

K-Tuned K-Swap Conversion Harness 92-95 Civic 94-01 Integra


K-Tuned K24 Intake Manifold Adapter
