Mishimoto Baffled Oil Catch Can for 07-11 Jeep Wrangler JK

(No reviews yet) Write a Review
SKU:
MMBCC-WR6-07PBE
$202.95

Out of stock

Description

Inlet 1/2" NPT

Outlet 1/2" NPT

Drain Plug Thread Size 3/8" NPT

Capacity 2 oz.

Purchase Includes
(1) Application-Specific Mounting Bracket 
(1) Black, Anodized 6061 Aluminum Catch Can 
(2) Silicone Hoses 
(2) Plastic Barbed Fittings 
(4) Worm Gear Clamps 
(1) Bronze Filter 
(1) Air Diverter 
(1) Internal Baffle & Rod 
(1) 3/8" NPT Plug 
(1) Large O-Ring 
Mounting Hardware 

Fits Jeep Wrangler, 2007-2011

Engine Codes 3.8L EGH V6

Chassis Codes JK

Material 6061 Aluminum

Install Torque Specs
22 in-lbs (2.5N*M) recommended for all worm-gear clamps. These clamps have an operating range of 18-27 in-lbs 2-3N*M. Do not exceed the maximum torque rating of 27 in-lbs (3N*M).

Note This kit has been confirmed to fit with the sPOD system.

This catch can has not been confirmed to fit with other aftermarket products such as air compressors or vacuum pump relocation kits (except for sPOD system).

After installation, Mishimoto recommends checking the contents of the baffled catch cans every 500 miles until a baseline is established. Oil blow-by accumulation will vary with ambient temperatures and driving conditions. It is important that the contents of the can do not rise above the internal baffle.

Jeeps are built to go places that don’t always involve asphalt. While these machines are made for exciting adventures, it’s important to pay attention to your engine and make sure that you’re able to take your Jeep anywhere, anytime, for as long as you want. We are here to help with our 2007-2011 Jeep Wrangler 3.8L V6 Baffled Oil Catch Can Kit. 

Using our standard 2 oz. can, this kit will reduce the amount of harmful blow-by oil that coats your intake tracts and cakes your valves with carbon deposits. Internal air diverters slow incoming air for more effective air/oil separation as a 50-micron bronze filter helps filter that air and an internal aluminum baffle prevents any caught content from being recirculated back into the system. 

With the off-roader in mind, our two-piece, 2.5mm thick steel bracket was specially engineered to withstand a heavy amount of movement and abuse. The mounting location is secure on the chassis, so you won’t have to be concerned about your bracket sustaining damage due to chassis movement. Each kit includes black rubber hoses, a black powder-coated bracket, and is a direct fit for your 2007-2011 3.8L Wrangler.


View AllClose